I'm working on a student project and planning to use the NI-myRIO or NI-USB with LabVIEW. I'm new to this environment and would appreciate a step-by-step guide or advice on:
- How to install the correct version of LabVIEW that supports myRIO.
- What additional software or toolkits (e.g., NI-RIO driver, Real-Time Module, FPGA Module) are required?
- How to connect and configure the myRIO device properly after installation.
- A simple example of a basic student project (like reading analog input or blinking an LED) to test that the setup works.
- Do you have any troubleshooting tips if myRIO is not recognized by LabVIEW?
I'm using Windows 11.
Any official or community links, screenshots, or sample code would be very helpful!
